Straight out of the box, this Recycler Banger had already gotten a strike in my book. It had a thick glass (quartz) glob/excess where the tube connected to the side of the banger, and you could see a lip that had formed from the end of the tube when the quartz was attached back into the banger. After only a couple of days of regular usage, I heard the glass snap while I was heating it up, and shortly after, I noticed smoke leaking from the side of the banger where the tube was attached. I found strike two with the Quartz Insert due to its tendency to hold a lot of the product when it cooled. It would take a long time to heat back up to release it unless you put the flame directly in the banger, which would then burn your product instead of vaporizing it. When the knot was removed, the flow of product was smooth as butter, with none of it getting stuck or lost in the crevices of the knots. That is until I came across strike number three with the Bubble Cap. With the Knot insert in, the end of the cap would be aimed directly into the beginning of the loop, which would then force all of the air intake to be pushed in that direction and essentially push the product through the loop as it was made to be used. After the insert was removed, the bottom of the cap wasn't being set or forced into its designated position but would roll around the banger both due to its round shape and the airflow causing it to move. When it wasn't aiming directly down at the bottom where the tube began, the product in the tube would stay still and eventually solidify again or burn if heat was still continuously applied. The airflow had to be in line for the functionality of the loop to be used. I held out hope that the Recycler Banger (excluding the cap and insert) would have looked like the one they had pictured but was disappointed and then let down after the rest of the troubleshooting. This could be made much better with a few tweaks, adjustments, and attention to detail.

bought good quality dab tools and glass here, the glass is a 5/5 and the tools are 4/5. Will buy here again.

Worth every penny! This thing rips!!!

This thing rips the big ones! You will need huge lungs if you like doing globs. It is wasting product if you try to do a normal size 1. Probably will need to get a little hotter than normal

This piece quickly became the, "here you clear it," banger. It packs a punch.